Advanced - NETGEAR GSM7212P User Manual

To set the System Usage Threshold, enter a number from 1 to 99. This sets the threshold
2.
level at which a trap is sent if consumed power is greater than the threshold power.
The Power Management Mode describes or controls the power management algorithm
3.
used by the PSE to deliver power to the requesting PDs. Select Static to indicate that the
power allocated for each port depends on the type of power threshold configured on the
port. Select Dynamic to indicate that the power consumption on each port is measured and
calculated in real-time.
To set the Auto Reset Mode, select Enable to reset the PSE pot without administrator
4.
intervention whenever a fault condition occurs. Select Disable to allow only the administrator
to reset the PSE port whenever a fault condition is detected.
To set the traps, select Enable to activate the PoE traps. Select Disable to deactivate the
5.
PoE traps. The default setting is enabled.
Click APPLY to send the updated configuration to the switch. Configuration changes take
6.
effect immediately.

Advanced

Use the Advanced page to configure the advanced PoE settings.
From the Advanced link, you can access the following pages:
• PoE Configuration
• PoE Port Configuration
• PoE PD Port Status
PoE Configuration
To display the Advanced PoE Configuration page, click System > Services > PoE >
Advanced > PoE Configuration. A screen similar to the following displays.
The Unit Selection field displays the current PoE unit. To change the PoE unit, select
1.
another unit from the drop down box.
The following table describes the PoE Configuration non-configurable fields.
Web Management User Guide
on page 59
on page 60
on page 63
59