Ip Rules - NETGEAR GSM7212P User Manual

Click ADD to add a new IP ACL to the switch configuration.
3.

IP Rules

Use these screens to configure the rules for the IP Access Control Lists created using the IP
Access Control List Configuration screen. What is shown on this screen varies depending on
the current step in the rule configuration process.
There is an implicit "deny all" rule at the end of an ACL list. This
Note:
means that if an ACL is applied to a packet and if none of the explicit
rules match, then the final implicit "deny all" rule applies and the
packet is dropped.
To display the IP Rules page, click Security
To configure rules for an IP ACL:
To add an IP ACL rule, select the ACL ID to add the rule to, complete the fields
1.
described in the following list, and click ADD. (Only displays ACL IDs from 1 to 99.)
Rule ID - Specify a number from 1–12 to identify the IP ACL rule. You can create up
•
to 12 rules for each ACL.
Action - Selects the ACL forwarding action, which is one of the following:
•
Permit - Forwards packets which meet the ACL criteria.
•
Deny - Drops packets which meet the ACL criteria.
•
Logging - When set to 'Enable', logging is enabled for this ACL rule (subject to resource
•
availability in the device). If the Access List Trap Flag is also enabled, this will cause
periodic traps to be generated indicating the number of times this rule was 'hit' during the
current report interval. A fixed 5 minute report interval is used for the entire system. A trap
is not issued if the ACL rule hit count is zero for the current interval. This field is visible for
a 'Deny' Action.
Web Management User Guide

ACL> Advanced
296

IP Rules.