NETGEAR GSM7212P User Manual page 194

Use Advertise Address to enter an integer that specifies the maximum number of times an
3.
ARP request will be retried. The range for this field is 0 to 10. The default value for Retries is
4.
Use Cache Size to enter the IP Address to be used to advertise the router.
4.
Use Maximum Advertise Interval to enter the maximum time (in seconds) allowed
5.
between router advertisements sent from the interface.
Use Advertise Lifetime to enter the value (in seconds) to be used as the lifetime field in
6.
router advertisements sent from the interface. This is the maximum length of time that the
advertised addresses are to be considered as valid router addresses by hosts.
Use Preference Level to specify the preference level of the router as a default router
7.
relative to other routers on the same subnet. Higher numbered addresses are preferred. You
must enter an integer.
Use CANCEL to cancel the configuration on the screen and reset the data on the screen to
8.
the latest value of the switch.
Use APPLY to send the updated configuration to the switch. Configuration changes take
9.
effect immediately.
Web Management User Guide
194