NETGEAR GSM7212P User Manual page 191

ARP Static Configuration
Use this screen to add an entry to the Address Resolution Protocol table.
Use IP Address to enter the IP address you want to add. It must be the IP address of a
1.
device on a subnet attached to one of the switch's existing routing interfaces.
Use MAC Address to specify the unicast MAC address of the device. Enter the address as
2.
six two-digit hexadecimal numbers separated by colons, for example 00:06:29:32:81:40.
Click ADD to add a new static ARP entry to the switch.
3.
Click DELETE to delete an existing static ARP entry from the switch.
4.
Click APPLY to change the MAC Address mapping to the IP. Configuration changes take
5.
effect immediately.
ARP Cache
Use this screen to show ARP entries in the ARP Cache.
Field
Port
IP Address
MAC Address
Click REFRESH to show the latest IP information.
Web Management User Guide
Description
The associated Unit/Slot/Port of the connection
Displays the IP address. It must be the IP address of
a device on a subnet attached to one of the switch's
existing routing interfaces.
The unicast MAC address of the device. The address
is six two-digit hexadecimal numbers separated by
colons, for example 00:06:29:32:81:40.
191