Creating A Hunt Rule - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Configuring Special Features
Managing Inbound Calls with Hunt Groups
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI
•
Resuming from a previous hunt with call forwarding to a receptionist
Global Rule: 500:name="Scheduling",102,103,101,hunt=ne;
45;240,cfwd=100
Line-Specific Rule: 102,103,101,hunt=ne; 45;240,cfwd=100
An incoming call is routed in "next station" order (hunt=ne). When a new call is
received, the system resumes the previous hunt. For example, suppose that
station 103 answered the most recent call to the group. A new call is routed to
the next station in the list, which is station 101. If the call is unanswered, then it
cycles to station 102, and so on. Each phone rings for 45 seconds (45;). After a
total of 240 seconds has elapsed, the call is forwarded to station 100
(240,cfwd=100).

Creating a Hunt Rule

Use the following procedure to create a global hunt rule or a line-specific hunt rule.
Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
Proceed as needed, depending on the type of hunt rule:
•
Global Rule: Click Voice tab > SIP. Scroll down to the PBX Parameters
section. Find the Hunt Groups field.
•
Line-Specific Rule: Click Voice tab > Line N, where N is the line interface
number. Scroll down to the Subscriber Information section. Find the
Contact List field.
Type your hunt group rule. See
"Examples for Hunt Rules," on
Click Submit All Changes. The phones reboot.
To verify the settings:
•
Global Rule: Place a call to the new hunt group by entering the extension
number or by using the Corporate Directory to select the group name and
dial the group.
"Syntax for Hunt Rules," on page110
page111.
6
and
113