Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 94

Configuring Phone Service and Voice Mail
Outbound Call Routing
STEP 4
SPA9000 Voice System Installation and Configuration Guide for Web UI
sdigits,<:1>[2-9]xxxxxxxxxS0 | sdigits,1[2-9]xxxxxxxxxS0
| sdigits,011xx. | sdigits,xx. | [1-8]xx)
•
For European countries:
(sdigits,xxS3 | sdigits,xxxS3 | sdigits,[1-9]xxxxxxxxS0
| sdigits,xx. | [1-8]xx)
•
For any other country:
(sdigits,xxxS3 | sdigits,[1-9]xxxxxxxxS0 | sdigits,xx. |
[1-8]xx)
NOTES:
•
sdigits: Steering digits for outbound calling.
•
If there is more than one line connected, then include the steering digits in
the following format: [sdigit1sdigit2]. For example, if the system is
connected to an ITSP via Line 1 (with 9 as steering digit) and to the PSTN via
the SPA400 on Line 2 (with 8 as steering digit), you would enter the
following dial plan:
([89],[3469]11S0 | [89],<:1408>[2-9]xxxxxx |
[89],<:1>[2-9]xxxxxxxxxS0 | [89],1[2-9]xxxxxxxxxS0 |
[89],011xx. | [89],xx. | [1-8]xx)
•
If there is only one line connected, then include a single steering digit. For
example, if system is connected to an ITSP via Line 1 only and a user needs
to press 9 to dial out, you would enter the following dial plan:
(9,[3469]11S0 | 9,<:1408>[2-9]xxxxxx | 9,<:1>[2-
9]xxxxxxxxxS0 | 9,1[2-9]xxxxxxxxxS0
| [1-8]xx)
Configure the corresponding dial plan rule for each line, as described in the
following steps:
a. Click Voice tab > Line 1.
b. Scroll down to the
c. Change the Dial Plan
you configured for L 1 in the Call Routing Rule.
In case you are using a Line (2, 3, 4) for backup of Line 1, you need to
NOTE
include in the backup Line dial plan, the entry of the Line 1 dial plan.
Dial Plan
section.
string, as needed, to include the same steering digit that
5
| 9,011xx. | 9,xx.
92