Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 62

Connecting the Equipment
Installing the SPA400
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI
Connect the provided Ethernet network cable to the ETHERNET port on the
SPA400, and then connect the other end of the cable to an Ethernet port on the
SLM224P switch.
If you are using the SPA400 for PSTN access, connect an RJ11 telephone cable to
one of the line ports on the SPA400, and then connect the other end of the cable to
the RJ11 wall outlet for the telephone service.
If you are using the SPA400 as a voice mail server, insert the provided USB 1. 1
voice mail module into the USB port.
IMPORTANT: For optimum voice mail performance, a SPA400 should be
NOTE
dedicated to the voice mail application when either of the following
conditions is met:
1. More than 2 FXO connections are required
OR
2. More than 2 users commonly access voice mail at the same time.
Connect the provided power adapter to the POWER port on the SPA400, and then
connect it to an electrical outlet.
If you would like to provide SPA400 with Power over Ethernet support,
NOTE
connect a POES5 Power over Ethernet adapter.
To verify your progress, confirm that the Power LED on the SPA400 flashes and
then shines steady green. The Status LED remains flashing until the SPA400 is
registered to the SPA9000.
You will learn how to configure the SPA400 in
NOTE
Service and Voice Mail."
Chapter 5, "Configuring Phone
4
60