Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 110

Configuring Special Features
Configuring the SPA932 Sidecar to Work with the SPA9000
STEP 10
STEP 11
SPA9000 Voice System Installation and Configuration Guide for Web UI
•
sub (required): The station name of the device and the IP address of the
SPA9000
The station name must exactly match the name that is entered in the
NOTE
phone configuration web page. The assigned names are displayed on
the PBX Status page (click the PBX Status link on the main
administration web page). For more information about entering a
station name, see "Setting Up Each Station" on page_57.
•
ext (required): The extension number on the specified phone, as in the
following example: xt=101@$PROXY. Alternatively, you can enter the usr
parameter with the assigned user ID, as in the following example:
usr=Smith@$PROXY.
•
vid (optional): Extension ID of the phone lines on the SPA962 (corresponds to
Ext 1 to 6; valid values, 1-6)
Click Submit All Changes.
To verify your progress, perform the following tasks:
•
Verify that the keys on the SPA932 are shining green. A flashing red light
indicates a problem with the syntax.
•
To test a speed dial key, press the key and verify that the destination phone
rings.
•
To test a BLF key, place a call from the destination phone and verify that the BLF
key flashes red on the SPA932.
6
108