Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 73

Configuring Phone Service and Voice Mail
Configuring the SPA9000
NOTE
STEP 1
STEP 2
STEP 3
SPA9000 Voice System Installation and Configuration Guide for Web UI
In the following procedure, you configure the SPA9000 to register to the SPA400. If
you are using the SPA400 as a voice mail server, you also enter the settings to
subscribe to that service.
The first part of this procedure is required whether you are using the SPA400 for
either PSTN access or voice mail. The second part of the procedure is required
only if you are using the SPA400 as a voice mail server.
Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
Click Voice tab > Line 2.
Any line can be used; however, for consistency throughout this Install Guide,
NOTE
Line 1 is used for ITSP service and Line 2 is used for the SPA400 interface.
Enter the following information about the SPA400:
•
User ID: 9000
This ID corresponds to the User ID that you will enter on the SPA400
configuration page. The entries must match exactly.
•
Proxy: Enter the IP address of the SPA400.
•
Registration Expires: 60
This setting ensures that the SPA9000 and SPA400 are resynchronized every
60 seconds. This setting ensures that any changes in settings are synchronized
on both devices.
5
71