Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 64

Connecting the Equipment
Installing the SPA400
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI
Enter the following settings:
Network Setup section:
•
Fixed IP address: Click the radio button, and then enter a valid IP address.
To avoid addressing conflicts, enter an IP address that is outside the
NOTE
range of addresses that are automatically assigned by your DHCP
server.
•
IP Subnet Mask: Enter the subnet mask for the subnetwork that the SPA400 is
on.
•
Gateway IP Address: Enter the IP address of the router for this subnetwork.
Domain Name Server (DNS) Address section:
•
Primary DNS: Enter the IP address of the primary DNS server.
•
Secondary DNS: Enter the IP address of the secondary DNS server.
NTP section:
•
NTP: Enter a fully qualified name of a Network Time Protocol server, such as
time.nist.gov.
•
Time Zone: Select the time zone for your region.
Click Save Settings. The SPA400 will reboot. To reconnect to the web
administration server, enter the new IP address for the SPA400 in the browser
Address bar.
4
62