Configuring The Voice Mail Server And Voice Mail Users - Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual

Configuring Phone Service and Voice Mail
Configuring the SPA400
NOTE
STEP 1
STEP 2
SPA9000 Voice System Installation and Configuration Guide for Web UI

Configuring the Voice Mail Server and Voice Mail Users

In the following procedure, you enter the settings that allow the SPA400 to act as a
voice mail server. These settings correspond to those that you entered on the Line
2 page in the SPA9000 configuration. Later you will enter corresponding settings
in the phone configuration.
This procedure is not required if you are using an external voice mail service.
If your web browser is not already connected to the SPA400 web configuration
utility, start Internet Explorer, and enter the IP address of the SPA400, and log on.
To configure the voice mail server, complete the following tasks (required):
a. Click Setup tab > Voice mail Server.
b. Enter the following information:
•
Server Port: 5090
The voice mail server uses this UDP port to listen for signalling between the
SPA400 and the SPA9000. This port must be different from the port number
that you entered on the SPA9000 Interface page.
•
SPA9000 subscriber ID: 8888
The SPA9000 uses the subscriber ID to subscribe to the SPA400 Voice mail
Server for obtaining notification.
•
Mailbox deposit number: 900
The SPA9000 uses the deposit number to deposit voice mail on the voice
mail server.
•
Mailbox manage number: 800
The SPA9000 uses the deposit number to access voice mail on the voice
mail server.
5
82