Linksys SPA921 - Cisco - IP Phone Installation And Configuration Manual page 71

Configuring Phone Service and Voice Mail
Configuring the SPA9000
STEP 4
STEP 5
SPA9000 Voice System Installation and Configuration Guide for Web UI
Use the following illustration as a guide.
•
SIP Port: You can keep the default value of 5060 for Line 1. Each line must have
a unique SIP port.
•
Contact List: Leave the default value, aa, for the Auto Attendant. Later, you can
make changes. Using this basic setting at this point simplifies your testing and
verification of the configuration.
Click Submit All Changes. The SPA9000 reboots.
To verify your progress, perform the following tasks:
•
After the devices reboot, click Voice tab > Info. Scroll down to the Line 1 Status
section. Verify that the line is registered. You may need to refresh the browser
screen to see the new status.
SPA9000 Voice tab > Info page: Line 1 Status section
•
Use an external phone, such as a cell phone, to place an inbound call to the
telephone number that was assigned by your ITSP. Assuming that you have left
the default settings in place, the Auto Attendant answers the call. You can then
dial an extension number to verify that the call rings to the station.
SPA9000 Voice tab > Line 1 page
5
69