Before you replace and lower the card retention mechanism, ensure that:
5
•
The tops of all adapters and filler brackets are flush with the alignment bar.
•
The notch in the top of the adapter or filler bracket fits around the alignment guide.
Gently press down on the card retention mechanism to secure the adapter bracket in place.
6
Close the card retention latch and gently press until it clicks into place.
7
NOTICE:
prevent the computer cover from closing properly or cause damage to the equipment.
Connect the adapter cable to the serial port adapter connector (SER2) on the system board.
8
Connect any cables that should be attached to the serial port adapter.
9
NOTE:
Replace the computer
10
Removing a Serial Port Adapter
Follow the procedures in
1
80
2
1
1
2
3
4
Do not route cables over or behind any installed cards. Cables routed over the cards can
See the documentation for the serial port adapter for information about the cable connections.
cover.
"Before You
fully seated card
not fully seated card
bracket within slot
bracket caught outside of slot
Begin."
3
4