Installing A Floppy Drive - Dell GX620 - 3.6GHz Desktop 1GB RAM 80GB Windows XP SFF User Manual

NOTE:
Since the following steps do not require the complete removal of the CD/DVD drive, it is not
necessary to disconnect the cables connecting the CD/DVD drive.
Remove the CD/DVD drive
2
NOTICE:
Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to
cables and the cable connectors.
Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
3
Then, lift up to remove the drive from the computer.
Disconnect the power and floppy-drive cables from the back of the floppy drive.
4

Installing a Floppy Drive

If you are installing a new drive:
1
Use a small flat-edge screw driver on the back side of the drive-panel insert to gently pop off
a
the insert.
Remove the four shoulder screws from the drive-panel insert.
b
If you are replacing an existing drive:
2
Remove the four shoulder screws from the existing drive.
and carefully set it aside.
1 2
1 drive release latch
2 floppy drive
121