Removing The Power-Adapter Port; Prerequisites; Procedure - Dell Inspiron 27 7000 Service Manual

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.

Prerequisites

1 Remove the stand.
2 Remove the back cover.
3 Remove the hard drive.
4 Remove the system-board
5 Remove the wireless card.
6 Remove the heat sink.
7 Remove the base cover.
8 Remove the rear-I/O bracket.
9 Remove the system board.

Procedure

NOTE: The following procedure only applies to computers shipped with Full High Definition (FHD) displays.
1 Remove the power-adapter port cable through the routing guides on the display-assembly base.
2 Remove the two screws (M3x5) that secure the power-adapter port to the display-assembly base.
3 Lift the power-adapter port, along with its cable, off the display-assembly base.
80

Removing the power-adapter port

Removing the power-adapter port
computer. After working inside your computer, follow the instructions in
shield.
48
After working inside
www.dell.com/