If applicable, before replacing the card retention mechanism, ensure that:
9
•
The tops of all cards and filler brackets are flush with the alignment bar.
•
The notch in the top of the card or filler bracket fits around the alignment guide.
Snap the card retention mechanism into place, securing the card(s) in the computer.
10
NOTICE:
the computer cover from closing properly or cause damage to the equipment.
NOTICE:
into the computer.
Connect any cables that should be attached to the card.
11
See the documentation for the card for information about the card's cable connections.
Replace the computer
12
If you installed a sound card:
13
Enter
a
192
2
1
1
fully seated card
2
not fully seated card
3
bracket within slot
4
bracket caught outside of slot
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
To connect a network cable, first plug the cable into the network wall jack and then plug it
cover.
System
Setup, select Audio Controller, and change the setting to Off.
3
4