NOTICE:
cables and the cable connectors.
Pull up the cable release tab to unlock it and disconnect the floppy-drive cable from the back of
5
the floppy drive.
Pull up the cable release tab to unlock it and disconnect the floppy-drive cable from the system
6
board.
Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
7
Then lift up to remove the drive from the computer.
Installing a Floppy Drive
NOTE:
screws located within the drive-panel insert.
186
Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to
1
2
In the event the replacement or new floppy drive does not have the shoulder screws, use the
1
2
cable release tab
data-cable edge connector