Dell GX620 - 3.6GHz Desktop 1GB RAM 80GB Windows XP SFF User Manual page 133

Lower the card retention latch and press it into place, securing the card(s) in the computer.
8
Replace the riser-card cage:
9
Align the tabs in the side of the riser-card cage with the slots on the side of the computer, and
a
slide the riser-card cage down into place.
Ensure that the riser cards are fully seated in the connectors on the system board.
b
Reconnect any cables that you removed in step 3.
10
Connect any cables that should be attached to the card.
11
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
the computer cover from closing properly or cause damage to the equipment.
Replace the computer
12
If you installed a sound card, perform the following steps:
13
Enter system setup, select Audio Controller, and change the setting to Off.
a
Connect external audio devices to the sound card's connectors. Do not connect external
b
audio devices to the microphone, speaker/headphone, or line-in connectors on the back
panel.
If you installed an network adapter card and want to turn off the integrated network adapter:
14
1 riser-card cage 3
2 slots 4
cover.
riser cards (2)
system board connectors (2)
1
2
3
4
133