Drives
Your computer supports:
•
One serial ATA hard drive
•
One optional D-module CD/DVD drive, second hard drive, or floppy drive in the module bay
General Installation Guidelines
NOTE:
For information on installing D-module drives, see the documentation that came with your
optional device.
Serial ATA hard drives should be connected to the connector labeled "SATA0" on the
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of
the drive and to the system board.
Drive Interface Connectors
Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one
connector matches a tab or a filled-in hole on the other connector. Keyed connectors ensure that the
pin-1 wire in the cable goes to the pin-1 end of the connector. The pin-1 end of a connector on a board
or a card is usually indicated by a silk-screened "1"printed directly on the board or card.
Serial ATA Connector
1
2
1
interface cable connector
2
interface connector
system
board.
227