Monitoring Flex Links And The Mac Address-Table Move Update - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Monitoring Flex Links and the MAC Address-Table Move Update
Rcv invalid packet count : 0
Rcv packet count this min : 0
Rcv threshold exceed count : 0
Rcv last sequence# this min : 0
Rcv last interface : Po2
Rcv last src-mac-address : 000b.462d.c502
Rcv last switch-ID : 0403.fd6a.8700
Xmt packet count : 0
Xmt packet count this min : 0
Xmt threshold exceed count : 0
Xmt pak buf unavail cnt : 0
Xmt last interface : None
Beginning in privileged EXEC mode, follow these steps to configure a switch to get and process MAC
address-table move update messages:
Command
Step 1
configure terminal
Step 2
mac address-table move update receive
Step 3
end
Step 4
show mac address-table move update
Step 5
copy running-config startup config
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table
Move Update
Table 16-1
MAC address-table move update information.
Table 16-1
Command
show interface
[interface-id] switchport
backup
show mac address-table
move update
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
16-8
Chapter 16
shows the privileged EXEC commands for monitoring the Flex Links configuration and the
Flex Links and MAC Address-Table Move Update Monitoring Commands
Purpose
Displays the Flex Link backup interface configured for an interface or
all the configured Flex Links and the state of each active and backup
interface (up or standby mode).
Displays the MAC address-table move update information on the
switch.
Configuring Flex Links and the MAC Address-Table Move Update Feature
Purpose
Enter global configuration mode.
Enable the switch to get and process the MAC
address-table move updates.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the switch startup
configuration file.
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
