Using Time Ranges With Acls - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 26 Configuring Network Security with ACLs
After you create an ACL, any additions are placed at the end of the list. You cannot selectively add ACL
entries to a specific ACL. However, you can use no permit and no deny access-list configuration mode
commands to remove entries from a named ACL. This example shows how you can delete individual
ACEs from the named access list border-list:
Switch(config)# ip access-list extended border-list
Switch(config-ext-nacl)# no permit ip host 10.1.1.3 any
Being able to selectively remove lines from a named ACL is one reason you might use named ACLs
instead of numbered ACLs.
After creating a named ACL, you can apply it to interfaces (see the
Interface" section on page
page

Using Time Ranges with ACLs

You can selectively apply extended ACLs based on the time of day and the week by using the time-range
global configuration command. First, define a time-range name and set the times and the dates or the
days of the week in the time range. Then enter the time-range name when applying an ACL to set
restrictions to the access list. You can use the time range to define when the permit or deny statements
in the ACL are in effect, for example, during a specified time period or on specified days of the week.
The time-range keyword and argument are referenced in the named and numbered extended ACL task
tables in the previous sections, the
and the
Time-based access lists trigger CPU activity because the new configuration of the access list must be
merged with other features and the combined configuration loaded into the TCAM. For this reason, you
should be careful not to have several access lists configured to take affect in close succession (within a
small number of minutes of each other.)
The time range relies on the switch system clock; therefore, you need a reliable clock source. We
Note
recommend that you use Network Time Protocol (NTP) to synchronize the switch clock. For more
information, see the
Beginning in privileged EXEC mode, follow these steps to configure a time-range parameter for an ACL:
Command
Step 1
configure terminal
Step 2 time-range time-range-name
Step 3
absolute [start time date]
[end time date]
or
periodic day-of-the-week hh:mm to
[day-of-the-week] hh:mm
or
periodic {weekdays | weekend | daily}
hh:mm to hh:mm
OL-8915-01
26-18) or to VLANs (see the
26-23).
"Creating Named Standard and Extended ACLs" section on page
"Managing the System Time and Date" section on page
Purpose
Enter global configuration mode.
Assign a meaningful name (for example, workhours) to the time range to
be created, and enter time-range configuration mode. The name cannot
contain a space or quotation mark and must begin with a letter.
Specify when the function it will be applied to is operational.
•
•
See the example configurations.
"Configuring VLAN Maps" section on
"Creating Standard and Extended IPv4 ACLs" section on page
You can use only one absolute statement in the time range. If you
configure more than one absolute statement, only the one configured
last is executed.
You can enter multiple periodic statements. For example, you could
configure different hours for weekdays and weekends.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring IPv4 ACLs
"Applying an IPv4 ACL to an
26-13.
5-1.
26-6,
26-15