Configuring Snmp; Default Snmp Configuration; Snmp Configuration Guidelines - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring SNMP

Configuring SNMP
These sections contain this configuration information:
•
•
•
•
•
•
•
•
•

Default SNMP Configuration

Table 25-4
Table 25-4
Feature
SNMP agent
SNMP trap receiver
SNMP traps
SNMP version
SNMPv3 authentication
SNMP notification type
1. This is the default when the switch starts and the startup configuration does not have any snmp-server global configuration

SNMP Configuration Guidelines

If the switch starts and the witch startup configuration has at least one snmp-server global configuration
command, the SNMP agent is enabled.
An SNMP group is a table that maps SNMP users to SNMP views. An SNMP user is a member of an
SNMP group. An SNMP host is the recipient of an SNMP trap operation. An SNMP engine ID is a name
for the local or remote SNMP engine.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
25-6
Default SNMP Configuration, page 25-6
SNMP Configuration Guidelines, page 25-6
Disabling the SNMP Agent, page 25-7
Configuring Community Strings, page 25-8
Configuring SNMP Groups and Users, page 25-9
Configuring SNMP Notifications, page 25-11
Setting the Agent Contact and Location Information, page 25-14
Limiting TFTP Servers Used Through SNMP, page 25-15
SNMP Examples, page 25-15
shows the default SNMP configuration.
Default SNMP Configuration
commands.
Default Setting
1
Disabled .
None configured.
None enabled except the trap for TCP connections (tty).
If no version keyword is present, the default is Version 1.
If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
If no type is specified, all notifications are sent.
Chapter 25 Configuring SNMP
OL-8915-01