Procedure With Password Recovery Disabled - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Recovering from a Lost or Forgotten Password
Note
Reload the switch:
Step 14
Switch# reload
Procedure with Password Recovery Disabled
If the password-recovery mechanism is disabled, this message appears:
The password-recovery mechanism has been triggered, but
is currently disabled.
through the password-recovery mechanism is disallowed at
this point.
reset back to the default system configuration, access
to the boot loader prompt can still be allowed.
Would you like to reset the system back to the default configuration (y/n)?
Returning the switch to the default configuration results in the loss of all existing configurations. We
Caution
recommend that you contact your system administrator to verify if there are backup switch and VLAN
configuration files.
•
•
Elect to continue with password recovery and lose the existing configuration:
Step 1
Would you like to reset the system back to the default configuration (y/n)? Y
Load any helper files:
Step 2
Switch: load_helper
Step 3
Display the contents of flash memory:
switch: dir flash:
The switch file system appears:
Directory of flash:
13
16128000 bytes total (10003456 bytes free)
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
29-6
This procedure is likely to leave your switch virtual interface in a shutdown state. You can see
which interface is in this state by entering the show running-config privileged EXEC command.
To re-enable the interface, enter the interface vlan vlan-id global configuration command, and
specify the VLAN ID of the shutdown interface. With the switch in interface configuration
mode, enter the no shutdown command.
Access to the boot loader prompt
However, if you agree to let the system be
If you enter n (no), the normal boot process continues as if the Mode button had not been pressed;
you cannot access the boot loader prompt, and you cannot enter a new password. You see the
message:
Press Enter to continue........
If you enter y (yes), the configuration file in flash memory and the VLAN database file are deleted.
When the default configuration loads, you can reset the password.
drwx
192
Mar 01 1993 22:30:48 cbs30x0-lanbasek9-mz.122-25.SEE.0
Chapter 29
Troubleshooting
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
