Configuring Flex Links And Mac Address-Table Move Update; Configuration Guidelines; Default Configuration - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring Flex Links and MAC Address-Table Move Update

Configuring Flex Links and MAC Address-Table Move Update
These sections contain this information:
•
•

Configuration Guidelines

Follow these guidelines to configure Flex Links:
•
•
•
•
•
Follow these guidelines to configure MAC address-table move update feature:
•
•

Default Configuration

The Flex Links are not configured, and there are no backup interfaces defined.
The preemption mode is off.
The preemption delay is 35 seconds.
The MAC address-table move update feature is not configured on the switch.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
16-4
Configuration Guidelines, page 16-4
Default Configuration, page 16-4
You can configure only one Flex Link backup link for any active link, and it must be a different
interface from the active interface.
An interface can belong to only one Flex Link pair. An interface can be a backup link for only one
active link. An active link cannot belong to another Flex Link pair.
Neither of the links can be a port that belongs to an EtherChannel. However, you can configure two
port channels (EtherChannel logical interfaces) as Flex Links, and you can configure a port channel
and a physical interface as Flex Links, with either the port channel or the physical interface as the
active link.
A backup link does not have to be the same type (Gigabit Ethernet, or port channel) as the active
link. However, you should configure both Flex Links with similar characteristics so that there are no
loops or changes in behavior if the standby link begins to forward traffic.
STP is disabled on Flex Link ports. A Flex Link port does not participate in STP, even if the VLANs
present on the port are configured for STP. When STP is not enabled, be sure that there are no loops
in the configured topology.
You can enable and configure this feature on the access switch to send the MAC address-table move
updates.
You can enable and configure this feature on the uplink switches to get the MAC address-table move
updates.
Chapter 16 Configuring Flex Links and the MAC Address-Table Move Update Feature
OL-8915-01