Chapter 9 Configuring Smartports Macros; Understanding Smartports Macros; Table - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring Smartports Macros
This chapter describes how to configure and apply Smartports macros on the switch.
For complete syntax and usage information for the commands used in this chapter, see the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•

Understanding Smartports Macros

Smartports macros provide a convenient way to save and share common configurations. You can use
Smartports macros to enable features and settings based on the location of a switch in the network and
for mass configuration deployments across the network.
Each Smartports macro is a set of command-line interface (CLI) commands that you define. Smartports
macros do not contain new CLI commands; they are simply a group of existing CLI commands.
When you apply a Smartports macro on an interface, the CLI commands within the macro are configured
on the interface. When the macro is applied to an interface, the existing interface configurations are not
lost. The new commands are added to the interface and are saved in the running configuration file.
There are Cisco-default Smartports macros embedded in the switch software (see
display these macros and the commands they contain by using the show parser macro user EXEC
command.

Table 9-1

Macro Name
cisco-global
cisco-desktop
OL-8915-01
Understanding Smartports Macros, page 9-1
Configuring Smartports Macros, page 9-2
Displaying Smartports Macros, page 9-8
Cisco-Default Smartports Macros
1
Description
Use this global configuration macro to enable rapid PVST+, loop guard, and dynamic
port error recovery for link state failures.
Use this interface configuration macro for increased network security and reliability
when connecting a desktop device, such as a PC, to a switch port.
C H A P T E R
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
9
Table 9-1). You can
9-1