Synchronization Of Port Roles - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs Also See for 3020 - Cisco Catalyst Blade Switch:
Table of Contents

Advertisement

Chapter 14
Configuring MSTP
Figure 14-4
Switch A
DP = designated port
RP = root port
F = forwarding

Synchronization of Port Roles

When the switch receives a proposal message on one of its ports and that port is selected as the new root
port, the RSTP forces all other ports to synchronize with the new root information.
The switch is synchronized with superior root information received on the root port if all other ports are
synchronized. An individual port on the switch is synchronized if
If a designated port is in the forwarding state and is not configured as an edge port, it transitions to the
blocking state when the RSTP forces it to synchronize with new root information. In general, when the
RSTP forces a port to synchronize with root information and the port does not satisfy any of the above
conditions, its port state is set to blocking.
OL-8915-01
Proposal and Agreement Handshaking for Rapid Convergence
Proposal
Root
Agreement
F
DP
RP
Root
F
DP
RP
Root
F
DP
RP
That port is in the blocking state.
It is an edge port (a port configured to be at the edge of the network).
Switch B
Designated
switch
F
Designated
switch
Proposal
F
Designated
switch
Agreement
F
F
DP
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Understanding RSTP
Switch C
F
RP
14-11

Advertisement

Table of Contents
loading

Table of Contents