Cisco 3020 - Catalyst Blade Switch Configuration Manual page 146

Controlling Switch Access with RADIUS
Beginning in privileged EXEC mode, follow these steps to define the AAA server group and associate a
particular RADIUS server with it:
Command
Step 1
configure terminal
Step 2 radius-server host {hostname |
ip-address} [auth-port port-number]
[acct-port port-number] [timeout
seconds] [retransmit retries] [key
string]
Step 3 aaa new-model
Step 4 aaa group server radius group-name
Step 5
server ip-address
Step 6 end
Step 7 show running-config
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
6-26
Purpose
Enter global configuration mode.
Specify the IP address or hostname of the remote RADIUS server host.
(Optional) For auth-port port-number, specify the UDP destination
•
port for authentication requests.
(Optional) For acct-port port-number, specify the UDP destination
•
port for accounting requests.
(Optional) For timeout seconds, specify the time interval that the
•
switch waits for the RADIUS server to reply before resending. The
range is 1 to 1000. This setting overrides the radius-server timeout
global configuration command setting. If no timeout is set with the
radius-server host command, the setting of the radius-server
timeout command is used.
(Optional) For retransmit retries, specify the number of times a
•
RADIUS request is resent to a server if that server is not responding
or responding slowly. The range is 1 to 1000. If no retransmit value is
set with the radius-server host command, the setting of the
radius-server retransmit global configuration command is used.
(Optional) For key string, specify the authentication and encryption
•
key used between the switch and the RADIUS daemon running on the
RADIUS server.
The key is a text string that must match the encryption key used
Note
on the RADIUS server. Always configure the key as the last item
in the radius-server host command. Leading spaces are ignored,
but spaces within and at the end of the key are used. If you use
spaces in your key, do not enclose the key in quotation marks
unless the quotation marks are part of the key.
To configure the switch to recognize more than one host entry associated
with a single IP address, enter this command as many times as necessary,
making sure that each UDP port number is different. The switch software
searches for hosts in the order in which you specify them. Set the timeout,
retransmit, and encryption key values to use with the specific RADIUS
host.
Enable AAA.
Define the AAA server-group with a group name.
This command puts the switch in a server group configuration mode.
Associate a particular RADIUS server with the defined server group.
Repeat this step for each RADIUS server in the AAA server group.
Each server in the group must be previously defined in Step 2.
Return to privileged EXEC mode.
Verify your entries.
Chapter 6 Configuring Switch-Based Authentication
OL-8915-01