Enabling And Configuring Port Security - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Chapter 19 Configuring Port-Based Traffic Control
Table 19-3
Table 19-3
Type of Port or Feature on Port
DTP
Trunk port
Dynamic-access port
SPAN source port
SPAN destination port
EtherChannel
Protected port
IEEE 802.1x port
Voice VLAN port
Flex Links
1. DTP = Dynamic Trunking Protocol
2. A port configured with the switchport mode dynamic interface configuration command.
3. A VLAN Query Protocol (VQP) port configured with the switchport access vlan dynamic interface configuration command.
4. You must set the maximum allowed secure addresses on the port to two plus the maximum number of secure addresses

Enabling and Configuring Port Security

Beginning in privileged EXEC mode, follow these steps to restrict input to an interface by limiting and
identifying MAC addresses of the stations allowed to access the port:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 switchport mode {access | trunk}
Step 4
switchport voice vlan vlan-id
Step 5 switchport port-security
OL-8915-01
summarizes port security compatibility with other port-based features.
Port Security Compatibility with Other Switch Features
1 2
port
3
4
allowed on the access VLAN.
Purpose
Enter global configuration mode.
Specify the interface to be configured, and enter interface configuration
mode.
Set the interface switchport mode as access or trunk; an interface in the
default mode (dynamic auto) cannot be configured as a secure port.
Enable voice VLAN on a port.
vlan-id—Specify the VLAN to be used for voice traffic.
Enable port security on the interface.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring Port Security
Compatible with Port Security
No
Yes
No
Yes
No
No
Yes
Yes
Yes
Yes
19-11