Configuring The Vmps Client; Entering The Ip Address Of The Vmps; Configuring Dynamic-Access Ports On Vmps Clients - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 10
Configuring VLANs
•
•
•
•
•
•
•
Configuring the VMPS Client
You configure dynamic VLANs by using the VMPS (server). The switch can be a VMPS client; it cannot
be a VMPS server.
Entering the IP Address of the VMPS
You must first enter the IP address of the server to configure the switch as a client.
Beginning in privileged EXEC mode, follow these steps to enter the IP address of the VMPS:
Command
Step 1
configure terminal
Step 2
vmps server ipaddress primary
Step 3
vmps server ipaddress
Step 4
end
Step 5
show vmps
Step 6
copy running-config startup-config
You must have IP connectivity to the VMPS for dynamic-access ports to work. You can test for IP
Note
connectivity by pinging the IP address of the VMPS and verifying that you get a response.
Configuring Dynamic-Access Ports on VMPS Clients
Caution
Dynamic-access port VLAN membership is for end stations or hubs connected to end stations.
Connecting dynamic-access ports to other switches can cause a loss of connectivity.
OL-8915-01
Trunk ports cannot be dynamic-access ports, but you can enter the switchport access vlan dynamic
interface configuration command for a trunk port. In this case, the switch retains the setting and
applies it if the port is later configured as an access port.
You must turn off trunking on the port before the dynamic-access setting takes effect.
Dynamic-access ports cannot be monitor ports.
Secure ports cannot be dynamic-access ports. You must disable port security on a port before it
becomes dynamic.
Dynamic-access ports cannot be members of an EtherChannel group.
Port channels cannot be configured as dynamic-access ports.
The VTP management domain of the VMPS client and the VMPS server must be the same.
The VLAN configured on the VMPS server should not be a voice VLAN.
Purpose
Enter global configuration mode.
Enter the IP address of the switch acting as the primary VMPS server.
(Optional) Enter the IP address of the switch acting as a secondary VMPS
server.
You can enter up to three secondary server addresses.
Return to privileged EXEC mode.
Verify your entries in the VMPS Domain Server field of the display.
(Optional) Save your entries in the configuration file.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring VMPS
10-27
Advertisement
Table of Contents
Troubleshooting
