Configuring Auto-Mdix On An Interface - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring Ethernet Interfaces

Configuring Auto-MDIX on an Interface

When automatic medium-dependent interface crossover (auto-MDIX) is enabled on an interface, the
interface automatically detects the required cable connection type (straight through or crossover) and
configures the connection appropriately. When connecting switches without the auto-MDIX feature, you
must use straight-through cables to connect to devices such as servers, workstations, or routers and
crossover cables to connect to other switches or repeaters. With auto-MDIX enabled, you can use either
type of cable to connect to other devices, and the interface automatically corrects for any incorrect
cabling. For more information about cabling requirements, see the hardware installation guide.
Auto-MDIX is enabled by default. When you enable auto-MDIX, you must also set the interface speed
and duplex to auto so that the feature operates correctly. Auto-MDIX is supported on all
10/100/1000-Mbps interfaces. It is not supported on 1000BASE-SX or -LX SFP module interfaces.
Table 8-2
Table 8-2
Local Side Auto-MDIX
On
On
Off
Off
Beginning in privileged EXEC mode, follow these steps to configure auto-MDIX on an interface:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
speed auto
Step 4 duplex auto
Step 5 mdix auto
Step 6 end
Step 7
show controllers ethernet-controller
interface-id phy
Step 8
copy running-config startup-config
To disable auto-MDIX, use the no mdix auto interface configuration command.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
8-16
shows the link states that result from auto-MDIX settings and correct and incorrect cabling.
Link Conditions and Auto-MDIX Settings
Remote Side Auto-MDIX With Correct Cabling
On
Off
On
Off
Purpose
Enter global configuration mode
Specify the physical interface to be configured, and enter interface
configuration mode.
Configure the interface to autonegotiate speed with the connected device.
Configure the interface to autonegotiate duplex mode with the connected
device.
Enable auto-MDIX on the interface.
Return to privileged EXEC mode.
Verify the operational state of the auto-MDIX feature on the interface.
(Optional) Save your entries in the configuration file.
Chapter 8 Configuring Interface Characteristics
With Incorrect Cabling
Link up Link up
Link up Link up
Link up Link up
Link up Link down
OL-8915-01