Setting The Agent Contact And Location Information - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs Also See for 3020 - Cisco Catalyst Blade Switch:
Table of Contents

Advertisement

Configuring SNMP
Command
Step 9
snmp-server trap-timeout seconds
Step 10
end
Step 11
show running-config
Step 12
copy running-config startup-config
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
informs). To enable a host to receive an inform, you must configure an snmp-server host informs
command for the host and globally enable informs by using the snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
informs, to the host. To disable informs, use the no snmp-server host informs global configuration
command. To disable a specific trap type, use the no snmp-server enable traps notification-types global
configuration command.

Setting the Agent Contact and Location Information

Beginning in privileged EXEC mode, follow these steps to set the system contact and location of the
SNMP agent so that these descriptions can be accessed through the configuration file:
Command
Step 1
configure terminal
Step 2
snmp-server contact text
Step 3
snmp-server location text
Step 4
end
Step 5
show running-config
Step 6
copy running-config startup-config
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
25-14
Purpose
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Set the system contact string.
For example:
snmp-server contact Dial System Operator at beeper 21555.
Set the system location string.
For example:
snmp-server location Building 3/Room 222
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Chapter 25
Configuring SNMP
OL-8915-01

Advertisement

Table of Contents
loading

Table of Contents