Disabling Ieee 802.1X Authentication On The Port; Resetting The Ieee 802.1X Authentication Configuration To The Default Values - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Configuring IEEE 802.1x Authentication
Disabling IEEE 802.1x Authentication on the Port
You can disable IEEE 802.1x authentication on the port by using the no dot1x pae interface
configuration command.
Beginning in privileged EXEC mode, follow these steps to disable IEEE 802.1x authentication on the
port. This procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
no dot1x pae
Step 4
end
Step 5
show dot1x interface interface-id
Step 6
copy running-config startup-config
To configure the port as an IEEE 802.1x port access entity (PAE) authenticator, which enables
IEEE 802.1x on the port but does not allow clients connected to the port to be authorized, use the dot1x
pae authenticator interface configuration command.
This example shows how to disable IEEE 802.1x authentication on the port:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# no dot1x pae authenticator
Resetting the IEEE 802.1x Authentication Configuration to the Default Values
Beginning in privileged EXEC mode, follow these steps to reset the IEEE 802.1x authentication
configuration to the default values. This procedure is optional.
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
dot1x default
Step 4
end
Step 5
show dot1x interface interface-id
Step 6
copy running-config startup-config
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
7-38
Chapter 7
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
Disable IEEE 802.1x authentication on the port.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the port to be configured.
Reset the IEEE 802.1x parameters to the default values.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring IEEE 802.1x Port-Based Authentication
OL-8915-01
Advertisement
Table of Contents
Troubleshooting
