Configuring Etherchannels - Cisco 3020 - Catalyst Blade Switch Configuration Manual

Configuring EtherChannels

Figure 28-3
Blade
Server 1
Client
Configuring EtherChannels
These sections contain this configuration information:
•
•
•
•
•
•
Make sure that the ports are correctly configured. For more information, see the
Note
Configuration Guidelines" section on page
Note After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical ports assigned to the port-channel interface, and configuration changes applied to the
physical port affect only the port where you apply the configuration.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
28-8
Load Distribution and Forwarding Methods
Blade
Server 16
Blade Switch with
source-based
forwarding enabled
EtherChannel
Cisco router
with destination-based
forwarding enabled
Client
Default EtherChannel Configuration, page 28-9
EtherChannel Configuration Guidelines, page 28-9
Configuring Layer 2 EtherChannels, page 28-10
Configuring EtherChannel Load Balancing, page 28-12
Configuring the PAgP Learn Method and Priority, page 28-13
Configuring LACP Hot-Standby Ports, page 28-14
Chapter 28 Configuring EtherChannels and Layer 2 Trunk Failover
(required)
(optional)
(optional)
(optional)
28-9.
"EtherChannel
OL-8915-01