Cisco 3020 - Catalyst Blade Switch Configuration Manual page 524

Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs Also See for 3020 - Cisco Catalyst Blade Switch:
Table of Contents

Advertisement

Understanding QoS
After classification, the packet is sent to the policing, marking, and the ingress queueing and scheduling
stages.
Figure 27-3
Classification Flowchart
configuration for classification.
IP and
non-IP
traffic
Check if packet came
with CoS label (tag).
Yes
Use CoS
Assign default
from frame.
port CoS.
Generate DSCP from
CoS-to-DSCP map.
Use the DSCP value to
generate the QoS label.
Done
Are there any (more) QoS ACLs
configured for this interface?
Yes
Read next ACL. Is there
a match with a "permit" action?
Yes
Assign the DSCP or CoS as specified
by ACL action to generate the QoS label.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
27-6
Start
Read ingress interface
Trust DSCP or
Trust IP
IP precedence
precedence
(non-IP traffic).
(IP traffic).
No
Generate the DSCP based on
IP precedence in packet. Use
the IP-precedence-to-DSCP
map. Use the DSCP value to
generate the QoS label.
No
No
Assign the default
DSCP (0).
Done
Trust CoS (IP and non-IP traffic).
Trust DSCP (IP traffic).
Assign DSCP identical
to DSCP in packet.
(Optional) Modify the
DSCP by using the
DSCP-to-DSCP-mutation
map. Use the DSCP
value to generate
the QoS label.
Done
Check if packet came
with CoS label (tag).
Yes
Use the CoS value to
generate the QoS label.
Generate the DSCP by using
the CoS-to-DSCP map.
Chapter 27
Configuring QoS
No
Assign the default port
CoS and generate a
DSCP from the
CoS-to-DSCP map.
Done
OL-8915-01

Advertisement

Table of Contents
loading

Table of Contents