Garmin G1000H Pilot's Manual page 473

To change transmission method:
1) While viewing the Report Status Page, press the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to move the cursor to the 1st or 2nd transmit method for the desired data report.
3) Turn the small FMS Knob to select the desired option (SAT SHORT BURST, SAT RUDICS, WI-FI, or NONE) as
shown in Figure 8-105. Sat Short Burst is generally used for transmission of data packets less than 300 bytes.
Wi-Fi is used only when the aircraft on the ground.
4) Press the ENT Key.
To enable/disable automatic send for Automatic Test Reports:
1) While viewing the Report Status Page, press the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to move the cursor to the AUTOMATIC SEND field.
3) Turn the small FMS Knob to select ENABLED of DISABLED.
4) Press the ENT Key.
To enable/disable periodic send for Periodic Test Reports:
1) While viewing the Report Status Page, press the FMS Knob to activate the cursor.
2) Turn the large FMS Knob to move the cursor to the PERIODIC SEND field.
3) Turn the small FMS Knob to select ENABLED of DISABLED.
4) Press the ENT Key.
190-01255-00 Rev. A
Figure 8-105 Select Transmission Method
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
ADDITIONAL FEATURES
461