Garmin G1000H Pilot's Manual page 512

APPENDIX B
5) After the navigation database files are copied to the bottom SD card, the display will appear as shown in Figure
B-4.
6) As instructed on the display, press any key to continue. The display will now appear as shown in Figure B-5.
7) Press any key to continue. The display will now appear as shown in Figure B-6.
8) Press the NO Softkey. The display now starts in normal mode. Since the database effective date is not yet valid,
it should not be loaded as the active database. The display now starts in normal mode. Do not remove power
while the display is starting.
9) Press the ENT Key to acknowledge the startup screen.
10) Turn the large FMS Knob to select the AUX Page group on the MFD.
11) Turn the small FMS Knob to select the System Status Page.
12) The new database is copied to the SD card in the bottom card slot of the PFD. Progress can be monitored in the
SYNC STATUS field. When copying is finished, 'Complete' is displayed.
500
Figure B-4 Standby Navigation Database Update Complete
Figure B-5 Navigation Database Verification Prompt
Figure B-6 Active Navigation Database Prompt
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
190-01255-00 Rev. A