Garmin G1000H Pilot's Manual page 392

ADDITIONAL FEATURES
HORIZON HEADING
The Horizon Heading is synchronized with the HSI and shows approximately 60 degrees of compass
heading in 30-degree increments on the Zero Pitch Line. Horizon heading tick marks and digits appearing
on the zero pitch line are not visible behind either the airspeed or altitude display. Horizon Heading is used
for general heading awareness, and is activated and deactivated by pressing the HRZN HDG Softkey.
TRAFFIC
Intruder aircraft at or below 500 ft. AGL may not appear on the SVS display or may appear as a
WARNING:
partial symbol.
Traffic symbols are displayed in their approximate locations as determined by the related traffic systems.
Traffic symbols are displayed in three dimensions, appearing larger as they are getting closer, and smaller
when they are further away. Traffic within 250 feet laterally of the aircraft will not be displayed on the SVS
display. Traffic symbols and coloring are consistent with that used for traffic displayed in the Inset map or
MFD traffic page. If the traffic altitude is unknown, the traffic will not be displayed on the SVS display. For
more details refer to the traffic system discussion in the Hazard Avoidance section.
AIRPORT SIGNS
Airport Signs provide a visual representation of airport location and identification on the synthetic terrain
display. When activated, the signs appear on the display when the aircraft is approximately 15 nm from
an airport and disappear at approximately 4.5 nm. Airport signs are shown without the identifier until the
aircraft is approximately 8 nautical miles from the airport. Airport signs are not shown behind the airspeed
or altitude display. Airport signs are activated and deactivated by pressing the APTSIGNS Softkey.
Airport
Sign with
Identifier
(Between
4.5 nm and
8 nm)
380
Figure 8-8 Airport Signs
Garmin G1000H ™ Pilot's Guide for the Bell 407GX
Traffic
Airport
Sign
without
Identifier
(Between
8 nm and
15 nm)
190-01255-00 Rev. A