G1000H Controls; Pfd Controls - Garmin G1000H Pilot's Manual

SYSTEM OVERVIEW

1.3 G1000H CONTROLS

The Audio Panel (GMA 350) are described in the CNS & Audio Panel.
NOTE:
The G1000H system controls are located on the PFD and MFD bezels and audio panel. The controls for the
PFD and MFD are discussed within the following pages of this section.

PFD CONTROLS

1 2
18
The following list provides an overview of the controls located on the PFD bezel (see Figure 1-2).
1 NAV VOL/ID Knob Turn to control NAV audio volume (shown in the NAV Frequency Box as a percentage)
2
NAV Frequency
Transfer Key
3
NAV Knob
4
Heading Knob
6
3 4 5
17
Figure 1-2 PFD/MFD Controls
Press to toggle Morse code identifier audio ON/OFF
Transfers the standby and active NAV frequencies
Turn to tune NAV receiver standby frequencies (large knob for MHz; small for kHz)
Press to toggle light blue tuning box between NAV1 and NAV2
Turn to manually select a heading
Press to display a digital heading momentarily to the left of the HSI and synchronize
the Selected Heading to the and current heading
Garmin G1000H
6 7 8
™ Pilot's Guide for the Bell 407GX
9
10
11
12
16
190-01255-00 Rev. A
13
14
15