Traffic Map Page - Garmin G1000H Pilot's Manual

HAZARD AVOIDANCE
Figure 6-85 Navigation Map Page Menu
Figure 6-86 Navigation Map Page Setup Menu
The Navigation Map Page Setup Menu provides a means in addition to the softkey for enabling/disabling
display of traffic. The setup menu also controls the map range settings above which traffic data (symbols
and labels) are decluttered from the display. If a map range larger than the map range setting is selected, the
data is removed from the map. Maps besides the Traffic Map Page use settings based on those selected for the
Navigation Map Page.

TRAFFIC MAP PAGE

The Traffic Map Page is specialized to show surrounding TIS traffic data in relation to the aircraft' s current
position and altitude, without clutter from the basemap. Aircraft orientation on this map is always heading up
unless there is no valid heading. Map range is adjustable with the RANGE Knob from 2 to 12 nm, as indicated
by the map range rings.
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. Once the aircraft is airborne, TIS switches from Standby to
Operating Mode and the G1000H begins to display traffic information. Refer to the System Status discussion
for more information.
Displaying traffic on the Traffic Map Page:
1) Turn the large FMS Knob to select the Map Page Group.
2) Turn the small FMS Knob to select the Traffic Map Page.
3) Confirm TIS is in Operating Mode:
Select the OPERATE Softkey to begin displaying traffic.
348
Figure 6-87 Navigation Map Page Setup Menu, Traffic Group
Garmin G1000H Pilot's Guide for the Bell 407GX
™
190-01255-00 Rev. A