Garmin G1000H Pilot's Manual page 378

HAZARD AVOIDANCE
The Navigation Map Page Setup Menu also controls the display of traffic. The setup menu controls the map
range settings. Traffic data symbols and labels can be decluttered from the display. If a map range larger than
the map range setting is selected, the data is removed from the map. Maps besides the Traffic Map Page use
settings based on those selected for the Navigation Map Page.
Traffic information can also be displayed on the PFD Inset Map by pressing the INSET Softkey. A traffic map
will appear in heading up orientation. Traffic information can also be overlaid with navigation, topographic
and optional XM Weather data.
Displaying traffic information (PFD Inset Map):
1) Select the INSET Softkey.
2) Select the TRAFFIC Softkey to display traffic data on the inset map (TRFC-1).
3) Select the softkey again to display the traffic-only inset (TRFC-2).
4) Select the softkey again to remove traffic data.
SYSTEM STATUS
The traffic mode is annunciated in the upper left corner of the Traffic Map Page.
Mode
Traffic System Test
Initiated
Operating
Standby
Traffic System Failed*
* See Table 6-20 for additional failure annunciations
If the traffic unit fails, an annunciation as to the cause of the failure is shown in the center of the Traffic Map
Page. During a failure condition, the Operating Mode cannot be selected.
366
Traffic Mode Annunciation
(Traffic Map Page)
TEST
(also shown in white in center of page)
OPERATING
STANDBY
(also shown in white in center of page)
FAIL
Table 6-19 Traffic Modes
Traffic Map Page
Annunciation
NO DATA Data is not being received from the traffic unit
Data is being received from the traffic unit, but the
DATA FAILED
unit is self-reporting a failure
FAILED Incorrect data format received from the traffic unit
Table 6-20 Traffic Failure Annunciations
Garmin G1000H Pilot's Guide for the Bell 407GX
™
Traffic Display Status Icon
(Other Maps)
Description
190-01255-00 Rev. A