3-Pack Ultra 160 Hot-Swap Expansion Kit; Hot-Swap Fan Assembly Replacement - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

3-Pack Ultra 160 Hot-Swap Expansion Kit

You can install an xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit in the server to
provide three additional hot-swap hard disk drives.
To install a xSeries 3-Pack Ultra160 Hot-Swap Expansion Kit:
1. Review the information in "Before you begin" on page 40, "Safety information"
2. Turn off the server and peripheral devices and disconnect all external cables
3. Release the side latches to remove the filler panels from the bays below the
4. Refer to the documentation provided with the option to assemble the hot-swap
5. Slide the hot-swap expansion option into the bays and attach it to the server
6. Refer to the documentation provided with the option to complete the installation
7. If you have other options to install or remove, do so now; otherwise, go to

Hot-swap fan assembly replacement

The server comes with three hot-swap fan assemblies. You do not need to turn off
the power to the server to replace a hot-swap fan assembly.
on page 109, and "Handling static-sensitive devices" on page 41.
and power cords; then, remove the cover and bezel. (See "Removing the cover
and bezel" on page 42.)
CD-ROM drive.
expansion option.
with the screws provided in the kit.
of the option. (See "System board internal cable connectors" on page 35 for
locations of the cable connectors on the system board.)
"Installing the server cover and bezel" on page 64.
Filler panels
Hot-swap expansion option
Installing options
63