IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual page 30

Note: After you replace the battery, you must reconfigure the system and reset the
v Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If the system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water.
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: Before you begin be sure to read "Before you begin" on page 40. Follow any
To replace the battery:
1. Review the information in "Before you begin" on page 40 and any special
2. Turn off the server and peripheral devices and disconnect all external cables
3. Remove the battery:
4. Insert the new battery:
20
Hardware Maintenance Manual: xSeries 342 Type 8669
system date and time.
special handling and installation instructions supplied with the replacement
battery.
handling and installation instructions supplied with the replacement battery.
and power cords; then, remove the server cover.
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery from its socket. The spring
mechanism behind the battery will push the battery out toward you as you
slide it from the socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.
a. Tilt the battery so that you can insert it into the socket, under the battery
clip.
b. As you slide it under the battery clip, press the battery down into the socket.