IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual page 53

DANGER
Electrical current from power, telephone, and communication cables is hazardous. To
avoid a shock hazard:
v Do not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.
v Connect all power cords to a properly wired and grounded electrical outlet.
v Connect to properly wired outlets any equipment that will be attached to this
product.
v When possible, use one hand only to connect or disconnect signal cables.
v Never turn on any equipment when there is evidence of fire, water, or structural
damage.
v Disconnect the attached power cords, telecommunications systems, networks, and
modems before you open the device covers, unless instructed otherwise in the
installation and configuration procedures.
v Connect and disconnect cables as described in the following table when installing,
moving, or opening covers on this product or attached devices.
To connect:
a. Turn everything OFF.
b. First, attach all cables to devices.
c. Attach signal cables to connectors.
d. Attach power cords to outlet.
e. Turn device ON.
Statement 5:
CAUTION:
The power-control button on the device and the power switch on the
power supply do not turn off the electrical current supplied to the device.
The device also might have more than one power cord. To remove all
electrical current from the device, ensure that all power cords are
disconnected from the power source.
3. Release the left and right side latches and pull the server out of the rack
enclosure until both slide rails lock.
Note: When the server is in the locked position, you can reach the cables on
the back of the server.
4. Lift the cover-release latch. Lift the cover off the server and set the cover aside.
To disconnect:
a. Turn everything OFF.
b. First, remove power cords from outlet.
c. Remove signal cables from connectors.
d. Remove all cables from devices.
Installing options
43