Table of Contents
Advertisement
2. To replace the hard drive tray, complete the following:
Removing and replacing FRUs
Field replaceable units (FRUs) must be installed only by trained service technicians.
Removing a non-hot-swap power supply
This procedure applies only to server models that have a non-hot-swap power
supply. See for information about the removal of a hot-swap power supply.
e. Remove the screws attaching the removable drive cage to the server cage.
f. Pull the removable drive cage out of the server cage.
g. Insert the new removable drive cage and attach the screws.
h. Attach the SATA and power cables to the removable drive cage. Then
connect the other ends to on the system board as they were connected
previously.
i. Attach both server side cover and the front upper bezel.
j. Insert the removable idb drive into the server and lock the drive.
a. If the server is powered on, ensure that the hard drive is in a hot swappable
state before unlocking and removing from the removable hard drive cage. If
the server is powered down, unlock the drive and remove it from the
removable drive cage.
b. Remove the screws from the upper cover of the drive tray.
c. Detach the hard drive from the connector within the removable drive tray.
d. Insert the new hard drive into the tray and connect the data and power
cables.
e. Attach the screws to the upper cover of the drive tray.
f. Insert the removable hard drive tray into the server and lock the drive.
Chapter 4. Removing and replacing server components
61
Advertisement
Table of Contents
