Microprocessor Installation In Model 5Rx - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

10. Set the fan sink into place.
11. Press down and latch the spring retention clip on the back of the fan sink (the
12. Press down and latch the spring retention clip on the front of the fan sink (the
13. Plug the fan sink into the fan sink connector on the system board (J46). Make
14. Reinstall the air baffle. Make sure the sides of the air baffle fit inside the
15. Reinstall the fan 3 assembly and make sure that the connector engages.
16. If you have other options to install or remove, do so now; otherwise, go to

Microprocessor installation in Model 5RX

To install an additional microprocessor in Model 5RX:
56
Hardware Maintenance Manual: xSeries 342 Type 8669
Microprocessor
release lever
Make sure the fan sink guide fits between the processor and the processor
socket.
Fan sink guide
side facing the back of the server).
side facing the front o f the server).
sure the cable is not in a position to interfere with the fan sink operation.
brackets on the server.
"Installing the server cover and bezel" on page 64.
1. Review the information in "Before you begin" on page 40.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then remove the cover (see "Removing the cover and bezel"
on page 42).
Fan sink
(Remove thermal tape
liner on installation)
Ensure correct alignment
of fan sink, mounting clip,
and mounting socket
Spring retention clip