Post Error Codes - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

AC Good LED DC Good LED
On Off
On On

POST error codes

In the following error codes, X can be any number or letter.
Error Code/Symptom
062 (Three consecutive boot failures using
the default configuration.)
101, 102 (System and processor error)
106 (System and processor error)
111 (Channel check error)
114 (Adapter read-only memory error)
129 (Internal cache error)
151 (Real time clock error)
161 (Real time clock battery error)
Description
Standby mode or dc
problem.
Power is OK.
FRU/Action
1. Run Configuration/Setup
2. Battery
3. System Board
4. Processor
1. System Board
1. System Board
1. Failing 15A adapter
2. Memory DIMM
3. System Board
1. Failing Adapter
2. Run Diagnostics
1. Processor
2. Optional Processor (if installed)
1. Run Diagnostics
2. Battery
3. System Board
1. Run Configuration/Setup
2. Battery
3. System Board
FRU/Action
1. Check system board cable connectors
J32, J33, and J35. Move jumper on J32's
extension cable to pins 2-3 to bypass
power control. If the DC Good LED comes
on, press Ctrl+Alt+Delete. Watch the
screen for any POST errors. Check the
System Error Log for any listed problems. If
the system powers up with no errors:
a. Power Switch Assembly
b. System Board
2. Remove the adapters and disconnect the
cables and power connectors to all internal
and external devices. Power-on the
system. If the DC Good LED comes on,
replace the adapters and devices one at a
time until you isolate the problem.
3. Power Supply
4. Power Backplane
5. System Board
N/A
Symptom-to-FRU index
93