IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual page 68

58
Hardware Maintenance Manual: xSeries 342 Type 8669
Note: You will need to reinstall the terminator card if you ever remove the
microprocessor and do not replace it.
Terminator
card
VRM 2
b. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the server; then, remove the
microprocessor from the package.
c. Using the orientation indicators on the microprocessor and on the
microprocessor socket, align the microprocessor pins over the socket; then,
carefully press the microprocessor into the socket.
d. Press down and latch the release lever.
6. Install the voltage regulator module (VRM) included in the microprocessor kit.
Attention: When installing or replacing a VRM, you must use the same type
of VRM that comes shipped on your server. Use of other VRMs might cause
your server to overheat.
a. Open the retaining clips located on the ends of the VRM connector, if
necessary.
b. Center the VRM over the VRM connector. Make sure that the VRM is
oriented and aligned correctly.
c. Press the VRM into the connector. Make sure the retaining clips snap into
the closed position.
Note: If you remove the microprocessor later, install a terminator card in the
vacant microprocessor socket and remove the appropriate VRM.
7. Install the heat sink.
Attention: You must install the same type of heat sink that comes installed in
your server.
Heat sink
(Remove thermal tape liner
on installation)
Microprocessor
orientation indicator
Microprocessor 2
VRM 1
Microprocessor
release lever