Additional Configuration/Setup Utility Menu Choices - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

v Error Logs
v Save Settings
v Restore Settings
v Load Default Settings
v Exit Setup

Additional Configuration/Setup Utility menu choices

When you install an IBM Remote Supervisor Adapter in the server, you can view
additional menu choices in the Configuration/Setup Utility program, such as:
v System Information
v PCI Slot Information
v Administrator Password
v Remote Control Security Settings
For a list of supported options for the server, refer to
http://www.ibm.com/pc/us/compat/ on the World Wide Web. To order an optional
Remote Supervisor Adapter, contact your IBM Reseller or an IBM marketing
representative.
26
Hardware Maintenance Manual: xSeries 342 Type 8669
Select this choice to view and identify system resources used by PCI devices.
PCI devices automatically communicate with the server configuration
information. This usually results in automatic configuration of a PCI device.
After making changes, select:
- PCI MLT to save the changes and return to the Advanced Setup menu.
- PCI Interrupt Routing to ignore the changes, restore the previous settings,
and return to the Advanced Setup menu.
– Integrated System Management Processor Settings
Select this choice to set the server to automatically restart after a
nonmaskable interrupt (NMI) occurs. The default setting for this menu item is
Enabled.
Select this choice to view the three most recent error codes and messages that
the system generated during POST. You can also select Clear error logs to
clear the contents of this log.
Note: System status messages available in the System Error Log in the
Configuration/Setup Utility program are provided only for trained IBM
service personnel.
Select this choice to save your customized settings.
Select this choice to delete your changes and restore the previous settings.
Select this choice to cancel your changes and restore the factory settings.
If you have made any changes, the program will prompt you to save the changes
or exit without saving the changes.
Select this choice to display information about the server.
Select this choice to view the properties of adapters installed in PCI slots.
Select this choice to set or change the administrator password.
Select this choice to set a remote-control password. When you set a
remote-control password, you can also set the number of failed attempts to enter
the correct remote-control password, and the duration before another attempt is
allowed.