Table of Contents
Advertisement
Ethernet Link Status Light: When this green light is on, there is an active
connection on the Ethernet port. The light stays on even if the server power is
turned off.
Information Light: This amber light is on when the system error log contains
information about certain conditions in the server that might affect performance.
System Error Light: This amber light is lit when a system error occurs. An LED on
the diagnostic LED panel may also be on to further isolate the error.
Powering on the server
You can start the server in several ways:
v You can turn on the server by pressing the power-control button on the front of
v If the server is turned on, a power failure occurs, and unattended-start mode is
v If AC power is present, the server is off, and the wake-up feature is enabled in
v The Integrated System Management Processor can also turn on the server.
Powering off the server
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
The server can be turned off as follows:
v You can turn off the server by pressing the power-control button on the front of
the server.
enabled in the Configuration/Setup utility program, the server will start
automatically when power is restored.
the Configuration/Setup utility program, the wake-up feature will turn on the
server at the set time.
the server. Pressing the power-control button starts an orderly shutdown of the
operating system, if this feature is supported by the operating system, and places
the server in standby mode.
Note: After turning off the server, wait at least 5 seconds before pressing the
power-control button to power the server on again.
9
General information
Advertisement
Table of Contents
Troubleshooting
