Microprocessor Installation In Models 1Rx, 2Rx, 4Rx, 1Tg, 2Tg, 4Tg - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

3. If two microprocessors are installed, the microprocessor installed in connector
Attention: To avoid damage and ensure proper server operation when you install a
Microprocessor installation in Models 1RX, 2RX, 4RX, 1TG, 2TG,
4TG
To install an additional microprocessor in Models 1RX, 2RX, 4RX, 1TG, 2TG, 4TG:
54
Hardware Maintenance Manual: xSeries 342 Type 8669
U69 is the startup processor, and the microprocessor installed in U68 is the
application processor.
new or an additional microprocessor, use microprocessors that have the
same cache size and type, and the same clock speed. Microprocessor
internal and external clock frequencies must be identical.
1. Review the information in "Before you begin" on page 40.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then remove the cover (see "Removing the cover and bezel"
on page 42).
3. Remove the fan 3 assembly by lifting the orange handle on top of the fan
assembly and pulling the fan assembly away from the server.
4. Remove the air baffle by grasping it at the sides and lifting it from the server.
Fan 3
Air baffle